Franks Ride On: I opened up my air box and brought to dealer. they recommend I not jet it, however it now pops on deceleration aolt. I also have a D G slip on. will this hurt the bike.?
Pete M: Which washer do I use in the bottom of the needle? The washer on the stock one is thicker than the one that comes with the kit.
Shawn Kearns: I have done all the these above mods, WITHOUT cutting a gapping hole in the air box! Works mint! Removing the stock air box rubber snorkel is all that is required. Funny how things catch on and the amount of people that follow..
PLII: Great video, thanks. I just know, if I was to do this to my DRZ, I would have a few parts left over, and I'm sure I would have to take it to a mechanic to fix up my poor mod conversion.
idriwzrd: Filmed by Michael J. Fox.
Brick Mansions: Like cutting a hole in the air box will ever do anything positive.
norincobro capri: Newbies please remember these mods are no good unless you first before open up your exhaust system. if you want to know what a 3 by 3 mod feels like before cutting up your air box take off your air box side cover in ride your bike. You will see that it just dies. Re jetting is as simple as raising the needle in your carburettor 1 millimetre.
mglsite: This guy does much neater work then me. I would never think on dressing off the hole that is going to be hidden by the seat.
bseriest: Why can't you just cut the 3x3 hole then turn the fuel screw up?
Jocelyn Martel: I really like your work, nice and clean
Jocelyn Martel: Kodiak Do you think you can make it for me I will pay you
Jocelyn Martel: Where is your shop located maybe I can stop by and have it done by you ?
Jocelyn Martel: 2000-2010 Suzuki DRZ400S Dirt Bike Performance Stage 1 Jet Kit Item No. TR-40-9880-59-OR is this kit is enough or I need something else Thank you
Jocelyn Martel: Where can I get all these parts is there a special kit that I can get Thank you
1983Bantam: this guy sounds like he has autism
Jason Ortiz (Boosted25): awesome video and its greatly appreciated! only thing i can think of to improve would be the little things like what size wrench was used to hold the needle. thanks again for the helpful vid!
calumkz: how does it work to improve performance?
CR2504life: Why do you buy a #25 pilot jet and a 140 main jet if your already buying a jet kit ??
Gary West: One thing I would do while doing the 3x3 mod shown is the large hole left wide open, I would put a small piece of 1/4"x1/4" square hole wire mesh screen to cover that hole otherwise you will have mice building a nest in your air box they can make a big mess in a air box
Codyp1814: Save time and don't remove the carburetor. Just loosen the clamps and angle the carb out. It is easier.